Markets · Electrical Power & Utilities
Custom silicone parts, insulating covers and profiles for the power sector
Technical silicone components made to customer drawing for medium-voltage networks (15 kV to 36 kV), substations, power transformers and switchgear. Formulated in-house for high dielectric strength, persistent hydrophobicity, and superior resistance to electrical tracking and UV weathering.
Direct manufacturer for electric power utilities, transformer builders, and insulator assemblers. Production from 30 pieces to high volumes, utilizing molding platens up to 500 x 550 mm and continuous extrusion up to 450 mm.
Power utility applications
In electrical distribution lines and substations, flashovers and insulation breakdowns occur when airborne dust, industrial pollution, or coastal salt fog combine with humidity. Elastobras technical silicone formulations prevent conductive moisture paths and resist electrical tracking over decades of outdoor exposure.
| Component | Application | Material & Properties | Field requirement |
|---|---|---|---|
| Transformer bushing covers | Primary and secondary bushings of distribution transformers (15 to 36 kV) | Technical silicone with high dielectric breakdown strength | Prevents accidental contact, phase-to-ground flashovers, and animal-induced short circuits; flexible installation |
| Modular insulator sheds | Bodies of post insulators, pin insulators, and medium-voltage surge arresters | Tracking- and erosion-resistant silicone compound | Maintains surface hydrophobicity to suppress leakage currents under heavy rain and contaminated environments |
| Wildlife & bird outage protectors | Disconnect switches, cable terminations, and crossarm insulators | UV- and ozone-resistant silicone or weather-grade EPDM | Eliminates service interruptions caused by bird strikes or animal contact on energized conductors |
| Transformer enclosure gaskets | Cubicle covers, junction boxes, and oil-immersed radiator flanges | Silicone, mineral-oil-resistant NBR, or cork-rubber | Continuous seal against insulating oil leakage and ambient water/dust penetration (IP66/IP68) |
| Damping inserts for overhead lines | Stockbridge-type vibration dampers and conductor bundle spacers | High-damping elastomeric compound | Dissipates aeolian vibrations in high-tension conductor cables without dynamic fatigue or ozone cracking |
Manufacturing envelope & installed capabilities
- Compression and injection molding: Platen dimensions up to 500 x 550 mm, suitable for transformer bushing boots, insulator sheds, wildlife caps, and anti-vibration inserts.
- Continuous extrusion: Hot-air tunnel vulcanization lines handling profiles and hollow tubing up to 450 mm width or diameter for protective covers and large enclosure seals.
- In-house compounding: Hardness ranging from 30 to 80 Shore A, tailored dielectric properties, utility standard colors (distribution gray, oxide red, translucent), and flame-retardant compounding.
- Quality assurance: ISO 9001:2015 certified plant in Curitiba, Brazil. Batch rheometer cure curves, Shore hardness verification, and full raw material traceability.